§ 30-146. Building disposition.

(a)

Specific to Zone T2. Building disposition shall be in determined Table 12.

(b)

Specific to Zones T3, T4, T4O, T5.

(1)

Newly platted lots shall be dimensioned according to Table 2 and Table 19 through Table 22.

(2)

Building disposition types shall be as shown in Table 12 and Table 2.

(3)

Buildings shall be disposed in relation to the boundaries of their lots according to Table 2, and Table 19 through Table 22.

(4)

One principal building at the frontage, and one outbuilding to the rear of the principal building, may be built on each lot as shown in Table 23c.

(5)

Lot coverage by building shall not exceed that recorded in Table 2 and Table 19 through Table 22.

(6)

Facades shall be built parallel to a rectilinear principal frontage line or to the tangent of a curved principal frontage line, and along a minimum percentage of the frontage width at the setback, as specified as frontage buildout on Table 2 and Table 19 through Table 22.

(7)

Setbacks for principal buildings shall be as shown in Table 2 and Table 19 through Table 22.

(8)

Rear setbacks for outbuildings shall be a minimum of 14 feet measured from the centerline of the rear alley or rear lane easement. In the absence of rear alley or rear lane, the rear setback shall be as shown in Table 2 and Table 19 through Table 22.

(c)

Specific to Zones T4O, T5.

(1)

The principal entrance shall be on a frontage line. Buildings or leasable spaces within buildings that are located on a corner lot may locate a principal entrance at such corner.

(2)

Newly platted lots shall be dimensioned according to Table 2 and Table 19 through Table 22. Subdivision of lots within projects more than two acres in size shall be pursuant to the following:

a.

These requirements shall apply only to projects in which ownership of the entire project is retained by the same persons or entities and in which uses are limited to multifamily uses or mixed use consisting of multifamily uses and commercial uses.

b.

Site plans required pursuant to section 30-141(c) shall allocate lot widths and building setbacks in compliance with Table 2 and Table 19 through Table 22.

c.

All criteria for building configuration must be met; as required in subsection (b) of this section, lot widths and setbacks for each building shall be shown on required site plans but subdivision of individual building sites within the permitted block perimeter shall not be required.

d.

All criteria for block lengths must be met and compliance with applicable subdivision requirements for establishment of proposed block perimeters and street locations shall be required.

(Code 2003, § 31-33; Ord. No. 13-04, § 1(exh. A), 2-21-2013; Ord. No. 16-03 , § 1, 2-18-2016)